–
| Pull button -2- out of handle -3- just far enough to allow actuating lever -arrow- to hang downwards. |
–
| Now press the handle onto selector lever as far as it will go. |
Installation position: Button points to driver. |
–
| Pull button out further and guide actuating lever -arrow- into handle. |
–
| Press button so that actuating lever engages in pull rod -4-. |
The button should now spring back onto the stop. |
–
| Slide sleeve -1- upwards, turning so that the two wide lugs on the sleeve locate in the slots in the handle and the sleeve can be felt to engage in the handle. |
–
| Shift selector lever to position „P“. |
|
|
|