audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Interrogating event memory > < Electrical/electronic components and fitting locations

A3 Mk1

Removing and installing automatic gearbox control unitJ217
Removing and installing automatic gearbox control unit -J217-
   
Removing
–  Remove wiper arms -1- → Electrical system; Rep. gr.92.
–  Pull off seal -2- for plenum chamber cover.
–  Raise plenum chamber cover -3- until it is possible to disconnect washer fluid hose going to washer jets.
–  If fitted, unplug electrical connector at washer jets.
  Caution
Risk of damage to plenum chamber cover.
Apply a small quantity of soap solution to transition between windscreen and plenum chamber cover. Then, starting at edge of windscreen, pull plenum chamber cover vertically up and out of retainer at windscreen.
–  Pull off plenum chamber cover.
  A92-0015
–  Switch off ignition, release multi-pin connector in direction of -arrow- and unplug from automatic gearbox control unit -J217-.
  A37-0209
–  Loosen bolts -arrows- and pull off automatic gearbox control unit -J217-.
  A37-0210
Installing
The remaining installation steps are carried out in the reverse sequence; note the following points:
–  Secure automatic gearbox control unit -J217-.
–  Slide guides -1- and -2- on multi-pin connector onto pins of control unit. Then secure catch on connector in direction of -arrow-.
–  Install wiper arms -1- → Electrical system; Rep. gr.92.
–  Perform self-diagnosis → Chapter.
–  If control unit has been renewed, initiate basic setting → Chapter.
  A37-0211

Interrogating event memory > < Electrical/electronic components and fitting locations