Audi Workshop Service and Repair Manuals

• ◆ The cutting point is marked with an indentation on the outside of the exhaust pipe.

Special tools and workshop equipment required

• ◆ Body saw V.A.G 1523 A
• ◆ Protective goggles

Procedure

• ‒ → Cut through exhaust pipe at right angles with body saw, e.g. V.A.G 1523 A at cutting point -arrow 2-.

• ‒ Position clamp 4 between side markings -arrows 1 and 3- when installing.

• ‒ → Install the clamping sleeve so that the ends of the bolts do not protrude over the lower edge of the clamping sleeve.
• ‒ Bolted connection facing to the front
• ‒ Stress-free alignment of exhaust system => Page 26-13