A3 Mk1
Cylinder head - exploded view |
1 - | Cylinder head |
q | Removing and installing → Chapter |
q | Checking for distortion → Fig. |
q | Machining limit → Fig. |
q | If renewed, refill system with fresh coolant |
2 - | Oil deflector |
q | Note installation position |
3 - | Cylinder head bolt |
q | Renew |
q | Note correct sequence when loosening → Anchor |
q | Note correct sequence when tightening → Anchor |
4 - | Gaskets for cylinder head cover |
q | Renew if damaged or leaking |
q | Before fitting, apply sealant at sealing points → Fig. and → Fig. |
5 - | Cylinder head cover |
q | Removing and installing → Chapter |
6 - | Gasket |
q | For ignition coil bolted onto cylinder head cover |
q | Renew if damaged |
7 - | Ignition coil |
8 - | 10 Nm |
q | For ignition coil bolted onto cylinder head cover |
9 - | Filler cap |
10 - | Seal |
q | Renew if damaged or leaking |
11 - | 10 Nm |
q | Tighten inner nuts first |
q | Tighten outer nuts in diagonal sequence |
12 - | Gasket |
q | For intake manifold |
q | Renew |
13 - | Cylinder head gasket |
q | Renewing → Chapter „Removing and installing cylinder head“ |
q | Installation position: Part No. towards cylinder head |
q | If renewed, change coolant in entire system |
|
|
|
|