audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing bracket for ancillaries > < Removing and installing poly V-belt

A3 Mk1

Removing and installing vibration damper
Removing and installing vibration damper
   
Removing
–  Remove poly V-belt → Chapter.
–  Unbolt vibration damper; counterhold on centre bolt with ring spanner.
  A13-0356
Installing
Installation is carried out in the reverse order; note the following:
–  When installing the vibration damper, use only genuine bolts (same as original equipment): → Parts catalogue.
l  The vibration damper can only be installed in one position. The hole -arrow- in the vibration damper must be located over the projection on the toothed belt sprocket.
–  Install poly V-belt → Chapter.
Tightening torque
  A13-0134
ComponentNm
Vibration damper to crankshaftProperty class 8.810 + 90° 1)2)
Property class 10.940
l  1) Renew bolts.
l  90° equals a 1/4 turn.

   

Removing and installing bracket for ancillaries > < Removing and installing poly V-belt