audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Reading measured value block > < Basic setting

A3 Mk1

Diesel Direct Injection and Glow Plug System (TDI 4 cyl.) >07.99
Self-diagnosis
Encoding control unit

If the appropriate code for the vehicle is not displayed or if the control unit has been replaced, the control unit must be encoded as follows.

  • ‒ Connect fault reader V.A.G 1551 (V.A.G 1552) and select the engine electronics control unit using "Address word" 01. For this purpose the ignition must be switched on.
    (Connecting fault reader and selecting engine electronics control unit .)
 
→ Indicated on display:
Rapid data transfer    HELP
Select function XX
  • ‒ Press keys 0 and 7 for the function "Code control unit" and confirm entry with Q key.
 
→ Indicated on display:
Code control unit    Q
Enter code number xxxxx (0-32000)
  • ‒ Enter the appropriate code number for this vehicle and confirm with Q key.

Code number

For vehicles with

00001

autom. gearbox

00002

manual gearbox
 
→ The display on fault reader V.A.G 1551 will show the control unit coding, e.g.:
028906021.. 1.9l    R4    EDC    G00SG    0203 ⇒
Coding 00002    WSC 12345
  • ‒ Switch the ignition off and then on again.

Note:

The next time the ignition is switched on the newly entered code will be activated.

If the ignition is not switched off and on after the correct code has been entered, it will not be possible to erase fault "01044 Control unit incorrectly coded").

  • ‒ Press the ⇒key.
 
→ Indicated on display:
Rapid data transfer    HELP
Select function XX
  • ‒ Press keys 0 and 6 for the "End output" function and press the Q key to confirm entry.

Reading measured value block > < Basic setting