Audi Workshop Service and Repair Manuals

Special tools and workshop equipment required

• ◆ Ring spanner set 3337
• ◆ High-temperature paste G 052 112 A3
  

Removing

• ‒ → Unplug 4-pin connector -arrow- for lambda probe.
• ‒ Unscrew lambda probe using special tool 3337.

Installing

When installing, note the following points:

Notes:

• ◆ The screw thread on the lambda probe is coated with a special paste. This paste must not be allowed to penetrate the openings on the probe.
• ◆ Tightening torque: 55 Nm.
• ◆ When installing, always make sure that the lambda probe connector is secured in the retainer on the bulkhead.
• ◆ A heat shield sleeve must be fitted on the connector.