Audi Workshop Service and Repair Manuals > A3 Mk1 > Running gear, front-wheel drive and four-wheel drive | Front suspension, drive shafts | Servicing front suspension | Exploded view of components: Subframe, anti-roll bar, wishbone - Audi A3

Exploded view of components: Subframe, anti-roll bar, wishbone - Audi S3 > < Servicing front suspension

Running gear, Front-wheel drive and four-wheel drive

Servicing front suspension

Exploded view of components: Subframe, anti-roll bar, wishbone - Audi A3



Anti-roll bar ◆ Removing and installing Bolt - 70 Nm + further 90° (1/4) turn ◆ Always replace after removing Bolt - 40 Nm + further 90° (1/4) turn ◆ Always replace after removing Bolt - 40 Nm + further 90° (1/4) turn ◆ Always replace after removing Pendulum support



Bolt - 20 Nm + further 90° (1/4) turn ◆ Always replace after removing Subframe ◆ Removing and installing Rubber bush Retaining clip Bolt, 25 Nm Bonded rubber bush ◆ One-piece design ◆ Replacing Stop block for subframe ◆ Repairing thread => Page 40-13 Welding nut in longitudinal member ◆ Captive nut in stop block cannot be reworked; entire stop block must be replaced if nut is damaged



Bolt - 100 Nm + further 90° (1/4) turn ◆ Always replace after removing Nut ◆ Self-locking ◆ Always replace together with bolt -Item 18- after removing Front left vehicle level sender -G78 ◆ For vehicles with automatic headlight range control ◆ Adjustment dimension for bracket with elongated hole => Fig.1 Bonded rubber bush ◆ Replacing => Page 40-34 Bolt - 70 Nm + further 90° (1/4) turn ◆ Always replace together with nut -Item 15- after removing Threaded plate



Nut, 45 Nm ◆ Self-locking ◆ Always replace after removing Ball joint ◆ Checking ◆ Removing and installing ◆ Mark installation position; on replacing wishbone, set to centre of elongated hole and check toe/camber ◆ Wheel alignment => Page 44-11 Bolt - 20 Nm + further 90° (1/4) turn ◆ Always replace after removing Wishbone ◆ Removing and installing



Bonded rubber bush ◆ Replacing => Page 40-34 Bracket Nut, 6 Nm Connecting link Bolt - 15 Nm + further 90° (1/4)turn ◆ Always replace after removing Bolt - 100 Nm + further 90° (1/4) turn ◆ Always replace after removing Nut - 15 Nm + further 90° (1/4)turn ◆ Self-locking ◆ Always replace after removing

Running gear, front-wheel drive and four-wheel drive
Front suspension, drive shafts / Servicing front suspension
Exploded view of components: Subframe, anti-roll bar, wishbone - Audi A3

Exploded view of components: Subframe, anti-roll bar, wishbone - Audi S3 > < Servicing front suspension