audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking rear axle camber - Front-wheel drive vehicles > < Balancing out camber at front axle - Audi A3

A3 Mk1

Running gear, Front-wheel drive and four-wheel drive
Wheel alignment
Adjusting camber at front axle - Audi S3
 
A44-0132
  • ‒ → Unscrew centre nut -arrow- at ball joint.
 
A44-0131
  • ‒ → Engage special tool T 40021 in transverse link as shown.
  • ‒ Screw in knurled screw at threaded pin.
  • ‒ Set nut on special tool such that it makes contact.
  • ‒ Unscrew nuts -arrows- and loosely screw in new ones.
  • ‒ Set specified camber by turning nut on special tool.
  • ‒ Tighten nuts of ball joint.

Tightening torque

Component

Nm

Ball joint to wishbone

75 1)

    1)    Replace nuts

Checking rear axle camber - Front-wheel drive vehicles > < Balancing out camber at front axle - Audi A3