Audi Workshop Service and Repair Manuals

The valid wheel/tyre combinations can be found in

=> Fault-finding binder; Wheels/tyres; Section 2

General

To ensure vehicle safety, tyres are not to be renewed individually, but rather at least on an axle basis.

The tyres with the deeper tread should always be fitted to the front wheels.

It is advisable to use tyres of the same make, design and tread type on all wheels.

Always replace rubber valve when renewing disc wheel or tyre.

Tyres are to be fitted with DOT mark facing outside of wheel; applies to left side of vehicle only in the case of tyres with directional tread pattern.

A wheel/tyre combination for the right side of the vehicle is to be fitted as spare wheel in the case of tyres with directional tread pattern.

Special tools and workshop equipment required

• ◆ Master set for wheel bolts T40004