Audi Workshop Service and Repair Manuals

Special tools and workshop equipment required

• ◆ Pressing-off lever 80-200

• ◆ Puller T10130

Removing

Detaching wiper arms

• ‒ → Use screwdriver to prise off caps at wiper arms -arrows- and unscrew hexagon nuts.
• ‒ Use puller T10130 to pull wiper arms -1- off wiper shaft and detach.

Removing wiper frame with linkage and wiper motor

• ‒ → Pull off rubber seal -2- of plenum chamber cover.
• ‒ Lift plenum chamber cover -3- such that washer fluid pipe can be disconnected.
• ‒ Unplug connector if fitted.
• ‒ Detach plenum chamber cover -3-.

• ‒ → Screw out bolts -1-.
• ‒ Carefully tip up -arrows- wiper frame -2- at front and unplug connector.
• ‒ Take wiper frame with linkage and wiper motor to left out of plenum chamber.

Note:

Use adhesive tape to stop wing becoming scratched.

Detaching wiper motor from wiper frame

• ‒ Use pressing-off lever 80-200 to prise wiper linkage off ball end
  -arrow-.
• ‒ → Unscrew nut -2-.
• ‒ Pull crank -1- off wiper motor.

• ‒ → Unscrew wiper motor from wiper frame -arrows-.

Installing

Install in reverse order, paying attention to the following:

• ‒ → Screw wiper motor without crank to wiper frame (9 Nm) -arrows-.
• ‒ Attach connector to wiper motor.
• ‒ Fit wiper motor with wiper frame in vehicle (5 Nm). To do so, slide wiper frame towards windscreen as far as it will go.

• ‒ Actuate flick wipe function.
• ‒ Allow wiper motor to run into park position.

• ‒ → Align crank -1- in parallel with wiper frame and tighten nut -2- to 18 Nm.
• ‒ Dimension x on left = Dimension x on right

Note:

Wiper frame has been removed in Fig.

• ‒ Set park position of wiper blades .

Tightening torque