Audi Workshop Service and Repair Manuals > A3 Mk2 > Brake system | ABS, ADR, TCS, EDL, ESP | Removing and installing parts of ABS/ESP system | Removing and installing brake pressure sender 1G201

Removing and installing brake pressure sender 1G201

Removing and installing brake pressure sender 1 -G201-

Special tools and workshop equipment required

t	Brake filling and bleeding equipment -VAS 5234-

t	Upgrade kit and extraction unit -V.A.G 1869/4-

Removing

Note

The brake pressure sender 1 -G201- is integrated in the ABS hydraulic unit -N55-.

–	Remove and install ABS hydraulic unit -N55-.

Installing

Installation is performed in reverse sequence; note the following:

–	Bleed brake system.

–	Bleed clutch hydraulics: → Rep. gr.30

–	Start calibration for brake pressure sender 1 -G201-.

–	Carry out ESP road test and system test.

To do so, use the vehicle diagnosis, testing and information system -VAS 5051 x- or -VAS 5052-.

–	Connect vehicle diagnosis, testing and information system -VAS 5051 x- or -VAS 5052- and select function.

–	See: Running gear

–	Brake system (Repair group 01; 45)

–	01 - Self-diagnosis compatible systems

–	03 - Brake electronics ABS/ESP Mark 60

–	J104 - Control unit for ABS/TCS/ESP, Functions

–	Calibrate brake pressure sender 1 -G201-

Audi Workshop Service and Repair Manuals