Audi Workshop Service and Repair Manuals

Exploded view - gear selector cable and gate selector cable up to model year 2007

Lubricate all bearings and moving surfaces with grease -G 000 450 02-.

1 -	Gear selector cable

q	Removing and installing → Chapter

q	Adjusting → Chapter

q	Secure to gate selector cable with cable tie → Fig.

2 -	Gate selector cable

q	Removing and installing → Chapter

q	Adjusting → Chapter

q	Secure to gear selector cable with cable tie → Fig.

3 -	Securing clips

4 -	Selector housing

5 -	Retaining clips

q

Renew

6 -

Bolt

q

20 Nm

7 -	Cable support bracket

q	Made of metal or plastic, depending on version

q	For correct version, refer to → Electronic parts catalogue

8 -

Grommet

q	Mounting for cable support bracket on gearbox

9 -

Bush

10 -	Cable end-piece

q	Secures gate selector cable to relay lever

q	Allocation → Fig.

q	Detaching from gate selector cable → Fig.

11 -	Cable end-piece

q	Secures gear selector cable to gearbox selector lever

q	Allocation → Fig.

q	Detaching from gear selector cable → Fig.

12 -	Securing clips

q	Removing → Fig.

q

Renew

13 -	Securing clip

q	Removing → Fig.

q

Renew

14 -	Bearing bushes

15 -	Relay lever

q	Installation position → Fig.

16 -	Slide block

17 -	Gearbox selector lever

q	With damper weight

q	Installation position → Fig.

q	After installing, adjust selector mechanism → Chapter

18 -

Nut

q

23 Nm

q	Self-locking

q

Renew

Identification of cable end-pieces The holes in the cable end-pieces have different diameters.

Cable end-piece for:	Dimension „a“
Gear selector cable to gearbox selector lever	10 mm
Gate selector cable to relay lever	8 mm

Cable end-piece for:	Dimension „a“
Gear selector cable to gearbox selector lever	20 mm
Gate selector cable to relay lever	18.5 mm

Installing gearbox selector lever –  When installing gearbox selector lever, make sure that the gap in the splines -arrow A- aligns with the wider spline -arrow B- on the selector shaft.

Detaching securing clip from relay lever –  Pull up clip -arrow- and detach securing clip.

Installation position: gearbox selector lever/relay lever 1 -  Gearbox selector lever  -  With damper weight 2 -  Relay lever  -  Locates in guide rail of gearbox selector lever via slide block -arrow-.

Detaching cable end-pieces from gear selector cable and gate selector cable –  Pull locking mechanism forwards -arrow 1- onto stop and then turn in direction of -arrow 2- to lock. –  Take cable -B- out of cable end-piece -A-.

Detaching and securing gear selector cable and gate selector cable Detaching –  Lift up tab and detach securing clip -3- for gear selector cable from gearbox selector lever -1-. Then pull gear selector cable off pin -arrow-. –  Lift up tab and detach securing clip -4- for gate selector cable from relay lever -2-. Then pull gate selector cable off pin -arrow-. Securing   Note t  Renew securing clips. t  Apply a small quantity of grease -G 000 450 02- to the pins -arrows-. –  Push gear selector cable onto gearbox selector lever -1- and secure with securing clip -3-. –  Push gate selector cable onto relay lever -2- and secure with securing clip -4-.

Position of cable tie securing selector cables –  Wrap cable tie round selector cables in a „figure-of-eight“-arrow- and secure cable tie as shown in illustration.