Audi Workshop Service and Repair Manuals

Removing and installing clutch master cylinder Special tools and workshop equipment required

t  Pliers -T10005- Removing   Note t  If you suspect a defective clutch master cylinder, perform function test prior to renewing → Chapter „Notes on removing and installing clutch master cylinder and slave cylinder“. t  When performing work in the footwell, put cloths on the carpet to protect it from possible brake fluid spills. –  Remove mounting bracket → Chapter.

–  Release retaining clip for operating rod on clutch master cylinder using pliers -T10005-.

–  Insert a spacer -A- between clutch pedal and stop, and press clutch pedal forward. t  Length of spacer = approx. 40 mm (e.g. 1/2” socket) –  Release retainer clip -B- and pull clutch master cylinder out of mounting bracket -arrows 1 and 2-.

Installing l  Clutch pedal in “released” position. –  Install retaining clip -2- on operating rod -1- for clutch master cylinder.

–  Insert a spacer -A- between clutch pedal and stop, and press clutch pedal forward. t  Length of spacer = approx. 40 mm (e.g. 1/2” socket) –  Secure clutch master cylinder on mounting bracket -arrows 1 and 2-.

–  Press operating rod -1- for clutch master cylinder in direction indicated (arrow) so that retaining clip -2- snaps into place in clutch pedal. –  Install mounting bracket → Chapter.