audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing clutch master cylinder > < Removing and installing mounting bracket

A3 Mk2

Removing and installing clutch position senderG476
Removing and installing clutch position sender -G476-
   
Removing
–  Remove engine cover panel -arrows-.
  A10-1564
–  Disconnect hoses -1-, -3- and -4-.
–  Release spring clips -2- and -5-, and remove air intake hose.
  A10-1571
–  Remove complete air cleaner housing → Rep. Gr.24.
  A10-1570
  Caution
When disconnecting the battery there is a risk of serious damage to electronic components:
Observe the correct procedure for disconnecting the battery.
–  Remove battery → Rep. Gr.27.
–  Remove battery tray -arrows- (detach front of battery tray from air duct if applicable).
  A10-1572
–  Unplug electrical connector -4-, and unclip and detach clutch position sender -G476- from master cylinder -arrow-.
  Note
-Items 1, 2 and 3- can be disregarded.
Installing
Installation is carried out in reverse sequence; note the following:
–  Install battery tray and battery → Rep. Gr.27.
–  Install air cleaner housing → Rep. Gr.24.
  A30-0123

Removing and installing clutch master cylinder > < Removing and installing mounting bracket