audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing oil seal for bevel box with gearbox installed > < Removing and installing flange shaft (left-side)

A3 Mk2

Renewing oil seal for flange shaft (left-side)
Renewing oil seal for flange shaft (left-side)
Special tools and workshop equipment required
   
t  Thrust piece -3305-
  W00-0695
t  Extractor tool -T20143/2-
t  Sealing grease -G 052 128 A1-
  W00-2958
Procedure
l  Gearbox in vehicle
–  Remove flange shaft (left-side) → Chapter.
–  Pull out flange shaft oil seal using extractor tool -T20143/2-.
  A39-0361
–  Lightly oil outer circumference of new oil seal.
–  Drive in new oil seal onto stop (take care to keep oil seal straight).
  N39-0769
–  Pack space between sealing lip and dust lip -arrow- half full with sealing grease -G 052 128 A1-.
–  Install flange shaft (left-side) → Chapter.
–  Check gear oil level in manual gearbox and top up as required → Chapter.
  N32-0001

Renewing oil seal for bevel box with gearbox installed > < Removing and installing flange shaft (left-side)