A3 Mk2
| Exploded view - clutch release mechanism, clutch slave cylinder |
| 1 - | Gearbox |
| q | Removing and installing → Chapter |
| 2 - | Input shaft oil seal |
| q | Renewing → Chapter |
| 3 - | Clutch slave cylinder with release bearing |
| q | Clutch slave cylinder and release bearing are one unit and can only be renewed together |
| q | Do not wash out bearing; wipe clean only |
| q | If bearing is noisy, renew together with slave cylinder |
| q | Removing and installing → Chapter |
| 4 - | Bolt |
| q | 12 Nm for metal clutch slave cylinder |
| q | 15 Nm for plastic clutch slave cylinder |
| q | 3x |
| q | Renew |
| q | Tighten carefully in several small steps; make sure that mounting lugs on clutch slave cylinder do not break off |
| 5 - | O-ring |
| q | Renew if damaged |
| q | Push onto pipe connection |
| q | Lubricate with brake fluid before installing |
