A3 Mk2
| Exploded view – Removing and installing rear final drive |
| 1 - | Bolt |
| q | 60 Nm + 90° |
| q | 3x |
| q | Always renew |
| 2 - | Stop plate |
| q | Fit onto bonded rubber bush → Fig. |
| 3 - | Rear final drive |
| q | Removing → Chapter |
| q | Installing → Chapter |
| q | Removing and installing (TT RS) → Chapter |
| q | Removing and installing bonded rubber bush → Chapter |
| 4 - | Washer |
| q | Installation position: chamfer (smaller diameter) faces subframe |
| 5 - | Bolt |
| q | For cross member |
| q | Only fitted on vehicles with cross member → Item |
| q | 4x |
| q | Always renew |
| 6 - | Bracket |
| q | Only fitted on vehicles with cross member → Item |
| 7 - | Nut |
| q | Only fitted on vehicles with cross member → Item |
| q | Tightening torque → Rep. gr.42 |
| q | 4x |
| q | Always renew |
| 8 - | Rear subframe |
| 9 - | Stop plate |
| q | Fit onto bonded rubber bush → Fig. |
| 10 - | Drive shaft |
| q | Removing and installing → Rep. gr.42 |
| 11 - | Cross member |
| q | Not fitted on vehicles with steel subframe → Item |
| q | Removing and installing → Rep. gr.42 |
