audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing valve stem oil seals with cylinder head installed > < Removing and installing camshafts

A3 Mk2

Removing and installing roller rocker fingers
Removing and installing roller rocker fingers
Special tools and workshop equipment required
   
t  Tool set for FSI engines -T10133-
  W00-1258
Removing
–  Remove battery → Rep. Gr.27.
–  Remove battery tray -arrows-.
–  Remove camshafts → Chapter.
  A10-1572
–  To aid assembly, mark the allocation of the roller rocker fingers and the shafts for the fingers.
–  Pull shaft for roller rocker fingers -1- (inlet side) out of cylinder head using puller -T10133/3-.
–  Remove roller rocker fingers.
–  Remove bolts -4- and -5-.
–  Pull the shaft -3- for the roller rocker fingers (exhaust side) out of cylinder head.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Fit new O-ring -2-.
–  Lubricate the bearings of the roller rocker fingers before installing.
–  Install camshafts → Chapter.
–  Install battery → Rep. Gr.27.
Tightening torques
  A15-0952
ComponentNm
Shaft for roller rocker fingers to cylinder head10
Screw plug for shaft (for roller rocker fingers) to cylinder head10 1)
l  1) Apply locking fluid when installing; refer to → Electronic parts catalogue for locking fluid.

   

Renewing valve stem oil seals with cylinder head installed > < Removing and installing camshafts