| When working on the fuel supply/injection system, pay careful attention to the following “6 rules”: |
| t
| Thoroughly clean all unions and surrounding areas before disconnecting. |
| t
| Place parts that have been removed on a clean surface and cover them over. Do not use fluffy cloths. |
| t
| Carefully cover or seal open components if repairs cannot be carried out immediately. |
| t
| Only install clean components; replacement parts should only be unpacked immediately prior to installation. Do not use parts that have been previously unpacked and stored away loose (e.g. in toolboxes, etc.). |
| t
| When the system is open: Do not work with compressed air if this can be avoided. Do not move the vehicle unless absolutely necessary. |
| t
| Unplugged electrical connectors must be kept clean and dry. Make sure connections are dry when attaching. |
|
|
|
