Audi Workshop Service and Repair Manuals

Removing and installing accelerator pedal module with accelerator position sender Special tools and workshop equipment required

t  For LHD vehicles: release tool -T10238-

t  For RHD vehicles: release tool -T10240-

Removing –  Remove cover for steering column -arrows-.

–  Detach electrical connector -2- by pressing release tab as far the stop -arrow-. –  If fitted, detach cable guide clip -1- at accelerator pedal module.

Audi A3 Cabriolet: –  Pull out release tab -1- as far as stop in direction of -arrow- and unplug electrical connector -2- at accelerator pedal module. All vehicles (continued): –  Use screwdriver to prise off cap. –  Remove bolt.

–  Push release tool -T10238- (or release tool -T10240- for RHD vehicles) fully into the slots provided, as illustrated -arrow-, and take off accelerator pedal module.

Installing l  Tightening torque → Chapter Installation is carried out in the reverse order; note the following: –  Attach cable guide clip -1- and electrical connector -2- to accelerator pedal module -5-. l  The connector must audibly engage. –  Press accelerator pedal module onto retaining studs -6-. –  Insert centring pin -7- into hole in underbody. –  Secure accelerator pedal module with bolt -3- and press on cap -4-.