Audi Workshop Service and Repair Manuals > A3 Mk2 > Running gear, front-wheel drive and four-wheel drive | Steering | Servicing electromechanical steering box (generations 2 and 3) | Removing and installing rubber bush for steering box (generation 2)

Removing and installing rubber bush for steering box (generation 2)

Removing

–	Remove bolts -2- and -3- and press heat shield -4- upwards slightly.

–	Loosen bolts -1- and -4- for steering box on left side of vehicle.

–	Loosen and remove bolts -2- and -3- for steering box on right side of vehicle.

For ease of illustration, the subframe (with steering box) is shown removed from the vehicle.

–	Lift steering box -4- slightly on right side of vehicle.

–	Detach clamp -1- and rubber bush -2- with bracket -3- from steering box -4-.

Installing

Installation is performed in reverse sequence; note the following:

Audi Workshop Service and Repair Manuals