audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Adjusting toe setting at rear wheels > < Centralising camber at front wheels

A3 Mk2

Adjusting camber at rear wheels
Adjusting camber at rear wheels
   
–  Unscrew nut -A- on bolted joint between upper transverse link and subframe, and loosely screw on new nut.
  A44-0183
–  Adjust camber by turning eccentric bolt -B- with 18 mm socket -T10001- (special tool).
  Note
The maximum adjustment range is 90° to the left or right of the centre position.
  A44-0186
–  Tighten nut -A- using ring spanner -T10179- (special tool).
–  Tightening torques → Chapter
  A44-0183
–  Use special tool as follows.
–  Check camber value again after tightening nut -A- → Chapter.
  A44-0185

Adjusting toe setting at rear wheels > < Centralising camber at front wheels