A3 Quattro V6-3.2L (BUB) (2008)
‹› Washer - 2 - must be installed so that there is a gap - arrow B - between washer and cover plate - 3 -.
-
Install ABS wheel speed sensor in wheel bearing housing.
-
Install brake disc.
-
Install brake carrier with brake caliper.
-
Install wheel and tighten.
‹› => [ Subframe, Diagonal Brace, Transverse Links, Tie Rod and Level Control System Sensor Assembly Overview ] See: Body and
Frame/Frame/Subframe/Rear Subframe/Service and Repair/Removal and Replacement/Subframe, Diagonal Brace, Transverse Links, Tie Rod and
Level Control System Sensor Assembly Overview
‹› => [ Wheel Bearing Housing, Bearing Unit, Trailing Arm with Mounting Bracket, Stone Deflector Assembly Overview ] See: Wheel Bearing
Housing, Bearing Unit, Trailing Arm with Mounting Bracket, Stone Deflector Assembly Overview
‹› => [ Shock Absorber and Coil Spring Assembly Overview ] See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Removal and Replacement/Rear Suspension/Shock Absorber and Coil Spring Assembly Overview
‹› => [ Stabilizer Bar Assembly Overview ] See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Rear Suspension/Stabilizer
Bar Assembly Overview
-
Vehicle alignment is required. Refer to => [ Wheel Alignment is Necessary When: ] See: Alignment/Service Precautions.