audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Knee airbag - country-specific version > < Removing and installing crash sensor for front airbags

A4 Cabriolet Mk2

Removing and installing crash sensor for side airbag (front)
Removing and installing crash sensor for side airbag (front)
  WARNING
Observe safety regulations for working on airbags → Chapter.
   
t  Removing
–  Disconnect battery earth strap.
–  Remove side trim  → Chapter.
–  Remove bolts -2- (2x).
t  Tightening torque: 9 Nm
–  Unplug connector at crash sensor -1- and take out crash sensor -1-.
  A69-0323
t  Installing
–  Install crash sensor -1- in reverse order of removal.
–  Switch on ignition.
  WARNING
Make sure nobody is in the vehicle when the battery is being connected.
–  Connect battery earth strap.
  Note
t  Observe measures to be taken after connecting battery → Electrical system; Rep. gr.27.
t  If the airbag warning lamp -K75- indicates a fault following installation, use the vehicle diagnostic, testing and information system -VAS 5051 A- to interrogate, erase and then re-interrogate the event memory.
  A69-0323

Knee airbag - country-specific version > < Removing and installing crash sensor for front airbags