audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Pneumatic block - allocation of components > < Removing and installing seat height adjuster unit

A4 Cabriolet Mk2

Removing and installing backrest cover panels
Removing and installing backrest cover panels
Special tools and workshop equipment required
   
t  Removal lever -80 - 200-
  W00-0353
1 - Backrest cover panel (right-side)
q   Removing and installing → Fig.
2 - Backrest cover panel (left-side)
q   Removing and installing → Fig.
3 - Retaining clip
4 - Bolt
q   Tightening torque: 2.5 Nm
q   Apply locking fluid when fitting
q   Locking fluid → Parts catalogue
5 - Outer section of belt opening
q   Removing and installing → Fig.
6 - Inner section of belt opening
q   With release lever
q   Illustration shows version for saloon
q   Removing: Remove backrest cover first → Chapter
q   Dismantling → Anchor
7 - Backrest frame

   
Removing and installing backrest cover panel
–  Protect backrest pan in area surrounding trim -1- with adhesive tape -2-.
–  Using removal lever -80-200-, prise off backrest cover panel from backrest pan starting from top (on inside).
–  Using great care, detach clip at front corner of backrest cover.
  A72-10149
Removing and installing outer section of belt opening
–  Carefully guide removal lever -80-200- between backrest cover and outer section of belt opening.
–  Carefully press outer section of belt opening off inner section.
  A72-10115

Pneumatic block - allocation of components > < Removing and installing seat height adjuster unit