A4 Cabriolet Mk2
Servicing bearings for Torsen differential |
Special tools and workshop equipment required |
t | Thrust plate -VW 401- |
t | Thrust plate -VW 402- |
t | Press tool -VW 407- |
t | Press tool -VW 412- |
t | Press tool -VW 432- |
t | Thrust plate -VW 447 H- |
t | Clamping sleeve -3116- |
t | Press tool -3118- |
t | -1-Internal puller -Kukko 21/5- |
t | -3-Splitter -Kukko 17/2- |
t | -4-Counter-support -Kukko 22/1- |
The shims for the Torsen differential must be re-determined after renewing the following parts → Anchor: |
t | End cover |
t | Inner race for needle bearing |
t | Torsen differential |
t | Ball bearing for Torsen differential |
Exploded view |
1 - | Ball bearing for Torsen differential |
q | Pressing off → Fig. |
q | Pressing on → Fig. |
2 - | Torsen differential |
q | Can only be serviced by manufacturer |
3 - | Inner race for needle bearing for Torsen differential |
q | Pulling off → Fig. |
q | Pressing on → Fig. |
4 - | Needle bearing for pinion shaft/Torsen differential |
q | Pulling out → Fig. |
q | Pressing in → Fig. |
|
|
|
|
|
|