–
| Screw the nut -T40188/1- onto the extractor -T40188/2-. |
–
| Fit the extractor -T40188/2- over the selector shaft. |
–
| At the same time, press the extractor -T40188/2- firmly into the oil seal -A--arrow 1- and screw in -arrow 2-. |
Note t
| Greater force can be exerted by hand in the direction of -arrow 1-, as the nut -T40188/1- has been screwed onto the extractor -T40188/2-. |
t
| The extractor -T40188/2- cuts into the oil seal -A-. |
t
| Take care not to damage the sealing surface at the gearbox and the selector shaft. |
l
| The extractor -T40188/2- must be seated extremely firmly in the oil seal. If necessary, press in the extractor -T40188/2- several times and screw in again. |
|
|
|