–
| Apply a drop of sealant (Ø approx. 5 mm) to all sealing points at joints between cylinder head and camshaft bearing caps. |
–
| Draw a bead of sealant (Ø approx. 3 mm) up to about half the height of camshaft bearing caps. |
–
| Tighten nuts for cylinder head cover diagonally and in stages. |
–
| Fit injector pipes one at a time, working from bottom to top and secure using torque wrench -V.A.G 1331- and 17 mm attachment (commercially available). |
Note t
| Ensure stress-free installation of injector pipes. |
t
| Make sure that retaining clips are positioned correctly. |
|
|
|