A4 Cabriolet Mk2
| Cylinder head - exploded view of components |
Note| Illustration shows right-side cylinder head. |
| 1 - | Cylinder head gasket |
| q | Renewing → Chapter „Removing and installing cylinder head“ |
| q | Installation position: Part No. towards cylinder head |
| q | If renewed, change coolant and engine oil |
| 2 - | Lifting eye |
| 3 - | 22 Nm |
| 4 - | Gasket |
| q | Renew if damaged or leaking |
| 5 - | Gasket for cylinder head cover |
| q | Renew if damaged or leaking |
| 6 - | Cylinder head cover |
| q | Removing and installing cylinder head cover (left-side) → Chapter |
| q | Removing and installing cylinder head cover (right-side) → Chapter |
| 7 - | Ignition coil |
| q | Use puller -T40039- to remove |
| 8 - | Special bolt, 9 Nm |
| q | Renew if damaged or leaking |
| q | Note correct sequence when tightening → Anchor |
| 9 - | Gaskets for cylinder head cover |
| q | Renew if damaged or leaking |
| 10 - | Gasket for cylinder head cover |
| q | Renew if damaged or leaking |
| 11 - | Semi-circular seal |
| q | Renew if damaged or leaking |
| 12 - | Cylinder head bolt |
| q | Renew |
| q | Note correct sequence when loosening → Anchor |
| q | Note correct sequence when tightening → Anchor |
| 13 - | Cylinder head |
| q | Removing → Chapter |
| q | Checking for distortion → Fig. |
| q | Machining dimension → Fig. |
| q | Installing → Anchor |
| q | If renewed, change coolant and engine oil |
|
|
|
|
