Audi Workshop Service and Repair Manuals

• Combi bolt
• ◆ 23 Nm
• Impact absorber
• ◆ To remove, unscrew hexagon bolts and pull out impact absorber to front.
• Hexagon bolt
• ◆ 45 Nm
• ◆ Impact absorber attached to right longitudinal member with 4 hexagon bolts.
• Bumper
• ◆ To remove, unscrew torx bolts at wheel housing liner.
• ◆ Pull out air duct grille at bumper.
• ◆ Unscrew combi bolts -1-.

• ◆ On installation, tighten to 23 Nm.
• ◆ Unclip bumper in direction of arrow from bracket -4- and detach to front.

• Left air vent
• ◆ Removing and installing
  
• Right air vent
• ◆ Removing and installing as for right air vent.
• Clip
• ◆ Press in wing on installation.
• Combi bolt
• ◆ 1.5 Nm
• ◆ Tighten the upper rear and front and lower screws in the named sequence for installing the bracket.
• Bracket
• ◆ Removing and installing
  => Page 63-7
• Spoiler
• ◆ Removing and installing

Fig.1    → Removing and installing air vents

• ‒ With a screwdriver -arrows- press the upper and lower locating hooks out of the catches.
• ‒ Pull out the air vent from the inside.