Audi Workshop Service and Repair Manuals

• Seat cushion

• ◆ Removing
• ‒ Raise seat as far as possible.
• ‒ Remove seat
• ‒ Remove seat extension, front trim panel and guide sleeves => Page 72-81
• ‒ Remove fitting panels => Page 72-94
• ‒ Remove spring cover => Page 72-96
• ‒ Disengage cover for electrics -2- beneath seat.

• ‒ If fitted, detach cushion cables (heating, seat occupied sensor).
• ‒ Fold up cushion -1- at front.
• ‒ Pull out cushion -1- at front.

Note:

The two seat springs and the corresponding rubber buffers at the rear between cushion and backrest drop out automatically on removal.

• ◆ Installing
• ‒ Ensure rubber buffers -3- are properly positioned in mounts at backrest.
• ‒ Insert springs -4- in cushion.
• ‒ Route cover for electrics -2- through between backrest and seat frame.

• ‒ Insert seat cushion -1- so that springs -4- rest on rubber buffers -3- on the backrest.
• ‒ Push seat cushion -1- towards the rear.
• ‒ Press down cushion -1- at front.
• ‒ If applicable, reconnect cushion cables.
• ‒ Engage cover for electrics beneath seat.

• Cover for electrics
• Rubber buffer (2x)
• Springs (2x)