audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing end cover, input shaft and drive pinion - work sequence > < Removing and installing 5th and 6th gears

A4 Mk1

5 & 6-Speed manual gearbox 01E, Front-wheel drive
Dismantling and assembling gearbox
Removing and installing input shaft, drive pinion and internal selector mechanism from bearing plate
 
V34-2648
  • Bearing plate
    • ◆ Servicing
  • Selector rod for 5th and 6th gear
    • ◆ Only renew together with follower for 5th and 6th gears
  • Follower for reverse gear
    • ◆ Pulling out ball sleeve => Page 34-95
    • ◆ Driving in ball sleeve => Page 34-96
 
V34-2648
  • Input shaft
    • ◆ Dismantling and assembling
  • Selector fork for 3rd and 4th gear
    • ◆ Can be replaced individually
    • ◆ Installation position: rib towards follower
  • Selector rod for 3rd and 4th gear
    • ◆ Only renew complete with follower for 3rd and 4th gear
  • Drive pinion
    • ◆ Dismantling and assembling
 
V34-2648
  • Selector rod for 1st and 2nd gear
    • ◆ Only renew together with selector fork for 1st and 2nd gear (secured together by means of a pin)
  • Follower for 1st and 2nd gear
    • ◆ Can be replaced individually
  • Circlip
    • ◆ Qty. 2
  • Locking bolts
    • ◆ Qty. 4
    • ◆ For aluminium bolt: 50 Nm
    • ◆ For steel bolt: 70 Nm
    • ◆ Mark fitting locations of aluminium and steel bolts; do not interchange when installing

Removing and installing end cover, input shaft and drive pinion - work sequence > < Removing and installing 5th and 6th gears