audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Draining torque converter > < Removing sleeve bearing from turbine shaft

A4 Mk1

Automatic gearbox 01N
Torque converter
Renewing the torque converter oil seal
 
W00-0154

Special tools and workshop equipment required

  • ◆ Extractor lever VW 681
 
W00-1250
  • ◆ Drift sleeve T10129
 
N32-0031

Removing

  • ‒ Remove gearbox .
  • ‒ Remove torque converter.
  • ‒ Mount gearbox on assembly stand => page 37-57 or place on a flat surface.
  • ‒ → Remove torque converter oil seal with oil seal extractor lever VW 681.
 
N32-0057

Installing

  • ‒ Lubricate the outer circumference and the sealing lips of the new oil seal with ATF.
    • ‒ Installation position: open side of oil seal towards gearbox
  • ‒ → Drive in torque converter oil seal with drift sleeve T10129 until drift sleeve reaches stop.

Draining torque converter > < Removing sleeve bearing from turbine shaft