-
● → Throttle cable -1- is attached to accelerator pedal and cable cam on throttle valve control part
-
‒ Pull securing clip -3- off grooved section of throttle cable sheath.
-
‒ Depress accelerator pedal into full throttle position.
Note:
A second mechanic is required for this step or use a spring tensioning rod braced against the steering wheel.
Vehicles with manual gearbox
-
‒ Adjust throttle cable by moving the securing clip -3- at the rubber grommet -4- in the support bracket -2- so that the full throttle position is attained at the throttle valve lever.
Vehicles with automatic gearbox
-
‒ Adjust throttle cable by moving the securing clip -3- at the rubber grommet -4- in the support bracket -2- so that the throttle valve is fully open and the kickdown switch clicks audibly.
All models
-
‒ Release accelerator pedal or remove spring tensioning rod.
-
‒ After adjusting the throttle cable, check position of throttle valve at idling speed and full throttle stops.
Checking adjustment (vehicles with automatic gearbox)
Special tools, testers and auxiliary items
-
◆ Hand multimeter V.A.G 1526 or V.A.G 1526 A
-
◆ Adapter set V.A.G 1594 A
-
‒ Pull 2-pin connector off kick-down switch (F8) in engine compartment (on the bulkhead).
|