-
‒ → Carefully lever off the retainer bar with a screwdriver -arrow-.
-
‒ Release catches and unplug control unit connectors.
-
‒ Take out engine control unit.
Installing
Install in reverse sequence; note the following points:
Important note:
After installing the new engine control unit the following operations must be performed:
-
‒ Interrogate and if necessary erase the fault memory => Page 01-9.
-
‒ Perform adaption of throttle valve control part -J338 => Page 24-138.
-
‒ Check the notes on coding new engine control units => Page 01-48.
-
‒ On vehicles with cruise control (identifiable by controls on steering column), activate the cruise control via the engine control unit.
=> Electrical system; Repair group 01; Self-diagnosis of cruise control system (CCS); Testing cruise control system (CCS)
-
‒ On models with an automatic gearbox, program the kick-down function .
-
‒ Perform adaption of immobilizer to engine control unit.
=> Electrical System; Repair Group 01; Self-diagnosis of electronic immobilizer; Adaptation procedure when engine control unit is replaced
-
‒ On models with engine code letters ANB, generate the readiness code => Page 01-58.
|