A4 Mk1
| Halogen headlights - exploded view of components |
Note| t | Fog lights can only be retro-fitted by installing triple light units; it is then also necessary to establish the appropriate wiring connections → Current flow diagrams, Electrical fault finding and Fitting locations. |
| t | If any work is performed which could affect the headlight setting, the headlights must be re-adjusted. |
| 1 - | Headlight lens |
| 2 - | Retaining clip |
| q | 7x |
| q | Secures headlight lens to headlight housing |
| q | Carefully lever off retaining clip using a screwdriver |
| q | When fitting, press in retaining clip by hand |
| 3 - | Trim |
| q | Engaged in headlight housing |
| 4 - | Seal |
| q | For headlight lens |
| q | Renewing |
| 5 - | Reflector |
| q | Unclip from retaining rings to remove |
| q | Press carefully into retaining rings when installing |
| q | Do not touch inside of reflector |
| 6 - | Bulb for side lights |
| q | 12 V, 4 W |
| q | Renewing bulb → Chapter |
| 7 - | Dipped/main beam bulb |
| q | 12 V, 60/55 W |
| q | Renewing bulb → Chapter |
| 8 - | Wiring harness |
| q | With connector housing and bulb holder for side light |
| 9 - | Cd strip |
| q | Clipped to headlight |
| 10 - | Housing cover |
| 11 - | Headlight range control motor |
| q | Headlight range control motor, left -V48- |
| q | Headlight range control motor, right -V49- |
| q | Removing and installing → Chapter |
| 12 - | Locator for reflector |
| q | Only on vehicles without headlight range control |
| 13 - | Headlight housing |
| q | Removing and installing → Chapter |
| 14 - | Turn signal |
| q | Removing and installing → Chapter |
| 15 - | Turn signal bulb |
| q | 12 V, 21 W |
| q | Orange |
| q | Renewing bulb → Chapter |
| 16 - | Bulb holder |
| q | For turn signal |
