audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing wiper motor > < Removing and installing wiper arms

A4 Mk1

Adjusting wiper arms
Adjusting wiper arms
   
Procedure
–  Operate “touch-wipe function” and allow wiper arms to move to end position.
–  Pry cover caps off wiper arms with a screwdriver.
–  Loosen nuts -arrows- several turns.
–  Release wiper arms -1- from wiper shafts one after the other by tilting slightly.
–  Remove nuts completely and detach wiper arms.
  Note
Disregard -item 2-.
–  Switch on ignition.
–  Operate “touch-wipe function” and allow wiper arms to move to end position.
–  Switch off ignition.
  A92-0022
–  Attach wiper arm with fitted wiper blade to wiper shaft and position wiper blade in line with markings -1- on windscreen as follows:
–  Check distance between tips of wiper blades and cowl panel grille at bottom edge of windscreen as follows:
  A92-0014
Dimension -a- = 20+ 8
– 5		mm
Dimension -b- = 28+ 8
– 5		mm

  Note
Dimensions indicate distance between tips of wiper blades and black cowl panel grille at bottom edge of windscreen.
–  Tighten nuts for wiper arms.
–  Switch on ignition.
–  Operate “touch-wipe function” and allow wiper arms to move to end position.
–  Switch off ignition.
–  Check setting of wiper arms again. Correct as necessary.
Tightening torque
   
ComponentNm
Wiper arm to wiper shaft16

   

Removing and installing wiper motor > < Removing and installing wiper arms