audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing belt end fitting > < Removing and installing belt buckle for seat-occupied sensor controlling deactivation of front passenger's airbag (country-speci

A4 Mk2

Removing and installing belt buckle (RS bucket seat)
Removing and installing belt buckle (RS bucket seat)
Removing
–  Move the front seat as far as possible to the rear and upwards.
–  Remove front seat → Chapter:
   
–  Unscrew bolt -3- and detach belt buckle -4-.
Installing
Install in reverse order of removal. Observe the following:
–  Remove bolt from belt buckle.
  Note
Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.
–  Switch on ignition.
  WARNING
The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery.
–  Connect battery earth wire with ignition switched on → Electrical system; Rep. gr.27.
  Note
If the airbag warning lamp -K75- indicates a fault following installation, you must interrogate, erase and then re-interrogate the event memory → Vehicle diagnostic tester.
Tightening torque:
  A69-10215
ComponentNm
Belt buckle to seat34

   

Removing and installing belt end fitting > < Removing and installing belt buckle for seat-occupied sensor controlling deactivation of front passenger's airbag (country-speci