audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing warning lamp for airbag deactivated on front passenger sideK145 (vehicles up to approx. week 43/03) > < Removing and installing airbag (front passenger side)

A4 Mk2

Removing and installing key-operated switch to deactivate airbag on front passenger side
Removing and installing key-operated switch to deactivate airbag on front passenger side
Special tools and workshop equipment required
t  Vehicle diagnostic tester
Removing
  WARNING
Observe safety regulations for pyrotechnic components → Chapter.
–  Remove glove box → Chapter.
   
–  Press retainers -arrows- with screwdriver.
–  Press out key-operated switch for airbag on front passenger side -1- to front.
  A69-0149
–  Insert key -3- in lock -2-.
–  Destroy key-operated switch -1- with key -3- inserted.
–  Break out lock -2-.
Installing
–  Press lock -2- with key -3- inserted into new key-operated switch -1- until lock -2- engages.
  Note
t  Observe measures to be taken after connecting the battery → Electrical system; Rep. gr.27.
t  If the airbag warning lamp -K75- indicates a fault following installation, you must interrogate, erase and then re-interrogate the event memory → Vehicle diagnostic tester.
  A69-0150

Removing and installing warning lamp for airbag deactivated on front passenger sideK145 (vehicles up to approx. week 43/03) > < Removing and installing airbag (front passenger side)