A4 Mk2
| Exploded view - Selector rod, connecting rod and push rod |
Note| Lubricate all bearings and moving surfaces with grease -G 000 450 02-. |
| 1 - | Ball socket |
| q | To remove, bend open peened points on selector rod → Item. |
| 2 - | Washer |
| 3 - | Bearing bush |
| q | To remove pull off retaining clip → Item. |
| 4 - | Bellows |
| 5 - | Gearbox selector lever |
| 6 - | Nut, 20 Nm |
| 7 - | Bolt, 20 Nm |
| 8 - | Connecting rod |
| q | To remove pull off retaining clip → Item. |
| 9 - | Retaining clip |
| 10 - | Bolt, 40 Nm |
| 11 - | Push rod |
| q | With bolt and washers |
| 12 - | Hexagon socket head bolt, 23 Nm |
| 13 - | Washer |
| 14 - | Gear lever bearing |
| q | Removing and installing → Chapter |
| 15 - | Clamping ring for bellows |
| 16 - | Bellows |
| q | Pull carefully over selector rod and push rod when removing |
| q | Align with markings on selector rod and push rod when installing |
| 17 - | Hexagon socket head bolt, 23 Nm |
| 18 - | Clamp |
| 19 - | Selector rod |
| 20 - | Joint for gear lever/selector rod |
| 21 - | Nut, 10 Nm |
| 22 - | Ball stud |
