–
| Apply a small quantity of sealant to the hatched area of the double bearing cap and the outer bearing cap adjacent to the camshaft adjuster; Sealant → Parts catalogue. |
–
| Install bearing cap (pay attention to dowel sleeves). |
–
| Install remaining bearing caps (pay attention to dowel sleeves). |
–
| Torque down remaining bearing caps. |
–
| Turn the crankshaft approx. 45° clockwise back to TDC at the toothed belt sprocket bolt and secure crankshaft with locking pin. |
–
| Install toothed belt (adjust valve timing) → Anchor. |
Note t
| After installing camshafts, wait for approx. 30 minutes before starting engine. Hydraulic valve compensation elements have to settle (otherwise valves will strike pistons). |
t
| After working on the valve gear, turn the engine carefully at least 2 rotations by hand to ensure that none of the valves make contact when the starter is operated. |
|
|
|