audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pipe (right-side) > < Removing and installing coolant pipe (rear)

A4 Mk2

Removing and installing coolant pipe (left-side)
Removing and installing coolant pipe (left-side)
   
Removing
l  Engine removed and in position on scissor-type assembly platform -VAS 6131 A- with gearbox attached.
  Note
Fit all heat shields and heat insulation sleeves in the original positions when installing.
–  Remove bolts -2- and -3- and lift out guide tube for oil dipstick.
–  Remove bolts -4- and -5-.
–  Move heat insulating sleeve protecting coolant hose (left-side) clear to one side.
–  Release hose clips -1- and -7-.
–  Detach coolant pipe (left-side) from coolant hoses.
  Note
Disregard -item 6-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Renew O-ring.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
t  Fit all heat shields and heat insulation sleeves in the original positions when installing.
–  Renew O-ring on guide tube for oil dipstick and insert guide tube into hole in top section of sump.
Tightening torques
  A19-10224
ComponentNm
Coolant pipe (left-side) to cylinder head9
Guide tube for dipstick to cylinder head9
Return pipe for power steering to coolant pipe9

   

Removing and installing coolant pipe (right-side) > < Removing and installing coolant pipe (rear)