audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Repairing wiring harnesses and electrical connectors > < Removing and installing main fuse carrier - vehicles with battery in engine compartment

A4 Mk2

Removing and installing positive terminal tap in plenum chamber - Audi RS4
Removing and installing positive terminal tap in plenum chamber - Audi RS4
   
Removing
–  With ignition switched off, disconnect earth wire at battery → Chapter.
–  Detach rubber seal of plenum chamber cover in -direction of arrow-.
–  Detach plenum chamber cover -1- to front.
  A27-0088
–  Screw out bolt -1-.
–  Release clip -2- in -direction of arrow A-.
–  Detach positive terminal tap from mount in -direction of arrow B-.
  A97-10193
–  Release clip -arrow A- and open cover -2- over positive terminal tap.
–  Release cover -1- over wires in -direction of arrow B-.
  A97-10194
–  Unscrew nuts -1- and -4- at positive wires.
–  Detach positive terminal tap.
Installing
Install in reverse order, paying attention to the following:
–  Connect battery. Action to be taken → Anchor.
Tightening torques
  A27-10048
ComponentNm
Positive wires to positive terminal tap15
Positive terminal tap to holder9

   

Repairing wiring harnesses and electrical connectors > < Removing and installing main fuse carrier - vehicles with battery in engine compartment