Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing positive terminal tap in plenum chamber - Audi RS4 >
< Removing and installing connector point in plenum chamber electronics box
A4 Mk2
Vehicle electrics
Electrical system
Wiring / Relay carriers, fuse carriers
Removing and installing main fuse carrier - vehicles with battery in engine compartment
Removing and installing main fuse carrier - vehicles with battery in engine compartment
Removing and installing main fuse carrier - vehicles with battery in engine compartment
Removing
–
With ignition switched off, disconnect earth cable at battery
→ Chapter
.
–
Detach rubber seal of plenum chamber cover in direction of
-arrow-
.
–
Remove plenum chamber cover
-1-
to front.
–
Fold cover
-2-
aside and unscrew nut
-3-
at electrical wire.
–
Unscrew nut
-1-
for fuse carrier at positive terminal.
Installing
Installation is carried out in the reverse order; note the following:
–
Connect the battery. Additional steps required
→ Anchor
.
Tightening torques
Component
Nm
Fuse carrier to positive terminal
6
Electrical wire to fuse carrier
6
Vehicle electrics
Electrical system
Wiring / Relay carriers, fuse carriers
Removing and installing main fuse carrier - vehicles with battery in engine compartment
Removing and installing positive terminal tap in plenum chamber - Audi RS4 >
< Removing and installing connector point in plenum chamber electronics box