A4 Mk3
Note
|
| Routing on rear lid |
| 1 - | Rear lid trim |
| q | Removed → Rep. gr.70 |
| 2 - | Bowden cable |
Note| t | When fitting a new Bowden cable, it must be routed from the rear lid lock on the inside of the rear lid along the rear lid hinge into the interior of the vehicle. |
| t | The clips for the Bowden cable are pre-positioned and are inserted in the corresponding holes. |
| q | Before removing, unclip rear lid lock cover. |
| q | First unclip from cable support bracket on rear lid lock, then detach from operating lever. |
| 3 - | Cover |
| q | Unclip |
| 4 - | Rear lid |
| q | When removing rear lid, disengage Bowden cable from rear lid lock and pull it out of rear lid. |
| 5 - | Rear lid lock |
| 6 - | Operating lever for manual release mechanism |
| q | When installing, first attach Bowden cable to operating lever, then press into cable support bracket on lid lock. |
| Routing on body |
| 1 - | Bowden cable |
| q | Route from rear lid lock via hinge into interior, as shown |
| 2 - | Rear lid lock |
| 3 - | Rear lid hinge |
| 4 - | Cover |
| q | Attached to rear lid hinge; lock in position on reverse side with tabs. |
| q | Bowden cable must be routed correctly in cover. |
| 5 - | Clip |
| q | The clips are pre-positioned and must be clipped into the corresponding holes. |
