audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing operating cable for door opener > < Removing and installing cover for door lock

A4 Mk3

Removing and installing door lock
Removing and installing door lock
  Caution
Risk of malfunctions.
To prevent the operating cable from being kinked or bent too much when it is disengaged/engaged, the door lock must be removed and installed together with the mounting bracket.
Therefore the operating cable must be engaged in/disengaged from the operating lever on the door lock with the components removed from the vehicle → Anchor.
Removing
–  Remove lock cylinder → Chapter.
–  Remove door trim → Rep. gr.70.
–  Remove cover for inner door panel → Chapter.
   
–  Remove cover for door lock → Chapter.
–  Turn operating cable on lever -1- 90° in direction of -arrow A- and take it out of cable support bracket -2-.
–  Turn operating cable on operating lever -3- for door lock in direction of -arrow B-.
l  The operating cable must be aligned with the opening on the operating lever.
–  Disengage operating cable from operating lever.
  A57-10320
–  Remove bolts -arrows-.
–  Remove door lock -1- and unplug electrical connector -2-.
  A57-10324
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Engage operating cable -3- in operating lever -2- for door lock.
–  Insert operating cable into support bracket -1- and turn lever -4- 90° -arrow-.
l  Lug on lever must engage audibly in cable support bracket.
–  Install cover for door lock → Chapter.
–  Install cover for inner door panel → Chapter.
–  Install door trim → Rep. gr.70.
–  Install lock cylinder → Chapter.
  A57-10322

Removing and installing operating cable for door opener > < Removing and installing cover for door lock