| Removing and installing seat longitudinal adjustment motor |
Note | The seat longitudinal adjustment motor can only be renewed together with the lower seat pan frame. |
WARNING | t
| Observe safety regulations for pyrotechnic components → Chapter. |
| t
| Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar. |
|
| –
| Attach front seat to seat repair stand -VAS 6136- → Chapter. |
Note | t
| Upper and lower seat pan frame can de separated and assembled without removing the padding. |
| t
| Only the seat position sensor has to be transferred to the new lower seat pan frame. |
| –
| Remove seat position sensor: |
| –
| Separate upper seat pan frame from lower seat pan frame → Anchor. |
WARNING | t
| Observe safety regulations for pyrotechnic components → Chapter. |
| t
| Before handling pyrotechnic components (e.g. plugging in the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar. |
|
| Installation is carried out in the reverse order; note the following: |
Note | Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly. |
WARNING | The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. |
|
Note | If the airbag warning lamp -K75- indicates a fault following installation, you must interrogate, erase and then re-interrogate the event memory → Vehicle diagnostic tester. |
|
|
|
