audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Detaching seat cover from padding (backrest with load-through hatch) > < Exploded view of cover and padding for split rear seat backrest (with load-through hatch)

A4 Mk3

Removing and installing seat cover and padding for split rear seat backrest (with load-through hatch)
Removing and installing seat cover and padding for split rear seat backrest (with load-through hatch)
Removing
–  Remove seat bench → Chapter.
–  Remove rear seat backrest → Chapter.
–  Remove head restraint → Chapter.
2/3 section (right-side) of split backrest with load-through hatch:
–  Remove centre armrest with flap for load-through hatch → Chapter.
–  Remove trim frame → Chapter.
–  Remove centre belt guide (rear) → Chapter.
   
Continuation for rear seat backrest (left and right):
–  Remove trim for locking mechanism → Chapter.
–  Remove head restraint guides  → Chapter.
–  Unclip plugs -2-.
1 - Seat cover
3 - Inner bearing
  A74-10214
–  Prise fastening strip (top) -1- off backrest pan -3-.
–  Prise piping -2- at side and bottom off backrest pan -3-.
  A74-10215
2/3 section (right-side) of split backrest with load-through hatch:
–  Prise out piping -1- and -3- in load-through hatch of backrest -2-.
Continuation for rear seat backrest (left and right):
–  Prise cover over inner bearing.
–  Prise cover over outer bearing.
–  Detach cover with padding from backrest pan.
  A74-10196
Installing
Installation is carried out in the reverse order; note the following:
–  Install head restraint guide with button (left-side).
–  Make sure button -2- moves freely after fitting trim -1-.
  A72-10658

Detaching seat cover from padding (backrest with load-through hatch) > < Exploded view of cover and padding for split rear seat backrest (with load-through hatch)