audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing/installing and checking condensation drain hose > < Removing and installing front right chest vent temperature sensorG386

A4 Mk3

Removing and installing dash panel vents and rear vent
Removing and installing dash panel vents and rear vent
  Note
t  The following illustration shows the positions of the components on an Audi A5 Coupé. The layout may differ slightly on the Audi A5 Sportback, Audi A4, Audi Q5 etc. The components are however to be removed and installed in the same manner as described for the Audi A5 Coupé.
   
t  Removing and installing dash panel vents -B- and -C- → General body repairs, interior; Rep. gr.70
t  The vent in the rear centre console is to be removed in the same manner as the dash panel vents → General body repairs, interior; Rep. gr.70.
  Caution
To avoid damaging the dash panel vent on removal, do not engage the hook -3438--A- at the slats of the vents -B- and -C-.
–  Switch off the ignition.
–  Open the appropriate vent.
–  Insert the hook -3438--A- in the vent as shown.
–  Swivel the hook -3438--A- by approx. 90° towards the vent housing and insert the hook in the disassembly holes in the vent housing.
–  Carefully pull the appropriate dash panel vent -B- or -C- out of the dash panel.
  A87-10436

Removing/installing and checking condensation drain hose > < Removing and installing front right chest vent temperature sensorG386